Ayush 1 Report post Posted August 26, 2007 Hello Everyone, I am a little screwed up with this LSI 110 of mine. The important fact being i recently recharged it with Rs 795 voucher and 5days now its going all waste. The problem: After a lot of throws, the PF and J5(maybe diode) got misaligned from its place, this resulted in no signal on the phone. While pressing the PF with thumb, everything was working fine, so i used the blower and got J5 and PF on its place. Now, i have full signal for 5 seconds and no signal for another 5 seconds. Its like signal comes and goes. I am unable to make any calls. I think i took some resistance out of its place from the area near the PF. As you can see in the picture, i tried fixing anonymous resistance and diode to that place but it didnt work. A lot of trial resulted in track lifting from the board, so now either the future of this phone is dull or i am sure i need to pull a wire. I would be greatful if anyone can revert back to me with a solution to this problem. Preferably circuit diagram or even a picture from this specific area of phone would be great help. regards Ayush Share this post Link to post Share on other sites
