Leaderboard

Requirements:- QXDM Not Required:- Root, Bootloader unlock Steps:- Part I:- GSM edge unlock 1. Select LTE from mobile networks settings. Remove SIM and switch off phone 2. Boot into bootloader mode and select BPTools, after phone boots, enable debugging 3. Map the comports correctly to QXDM 4. Airplane mode 5. In QXDM, open command prompt, type spc=000000 6. Open NV browser, look for item 441 and make it 0x383 or 0xFFF in band line, click write 7. Look further for NV item 946, write 0x0028 in band pref 8. Lastly item no 1877 and write 2622339 to rf_bc_config line 9. Reboot 10. Phone now boots in global mode, insert GSM SIM and use with EDGE data. CDMA section remains untouched. Part II:- 3G HSPA+ UMTS 2100 mhz unlock (part II only after getting Edge signal) 1. Select LTE from mobile networks settings. Remove SIM and switch off phone 2. Boot into bootloader mode and select BPTools, after phone boots, enable debugging 3. Map the comports correctly to QXDM 4. Airplane mode 5. In QXDM, open command prompt, type spc=000000 6. NV item 946, write 0x0EA8 in band pref 6. NV item 1877 and write 245891456 to rf_bc_config line 7. Full flash current firmware by fastboot with emphasis on fastboot erase modemst1, fastboot erase modemst2 8. Phone boots in global mode with HSPA+ Note:- Firmware flashing will remove unstable signal issue. All the changes will be permanent. CDMA/evdo remains as it was earlier.

Due to a large section of buyers now opting to purchase GSM enabled CDMA device, I add another device for CDMA data provisioning. There are no special requirements to enable CDMA data on VZW G3. Root is not required. This is applicable to those users whose manual APN of #777 does not enable data. 1. From the dialpad, ##PROGRAM985, go to port test, switch it on. Diag mode will be ON. 2. With data enabled SIM inside, using DFS, go to data section and select, evdo_MFPA 3. Enable all the six profiles with omhtest@omh.relianceinfo.com in the MIP section fields and write. 4. May sometimes need to make APN as #777 if data does not start.

Doctor on a spree. I tried on moto x 1st Gen and was successful in getting gsm signal. Calls sms working fine. Data somehow not working. Thanks Doc for authentic n exclusive unlocks

Ordered the Redmi Note 3 yesterday for my son in grey color. Will post my feedback regarding CDMA performance after I receive it. In the meanwhile came across this video highlighting the hidden screen/body strength from a un-certified screen. Seems quite good for Rs. 9999/- phone -

There are two variants of the same model in Verizon lineup. One is factory GSM unlocked and the other is NOT GSM unlocked. This method is based on the small box packing GSM/CDMA variant of Verizon. Requirements:- DFS or QPST, RGERUC or RECRUC068 sim card Root the handset with Kingroot or any other method available. To enable diag mode if ##3424# does not respond:- adb shell su setprop sys.usb.diag.config diagon 1. SPC=000000, Make RTRE config to RUIM pref and reboot 2. write PPP USR and PASS (select MDR only with evdo rev A_ehrpd) in data section 3. Select 'pref mobile IP' in MIP section and enable all six profiles 4. Entire process with no SIM inside and airplane mode turned on **This is applicable for the global version not the CDMA only version.